×
Suggest this Article to:
TOP INDEXERS
Public Article
-
verified
The Adhesive Strength of Epoxy/Sol-Gel Materials Modified by Various Ratio of γ-Al2O3 Nanoparticles Authors
ISSN: 2369 - 3355
Publisher: author
The Adhesive Strength of Epoxy/Sol-Gel Materials Modified by Various Ratio of γ-Al2O3 Nanoparticles Authors
Indexed in
Technology and Engineering
ARTICLE-FACTOR
1.3
Article Basics Score: 2
Article Transparency Score: 2
Article Operation Score: 2
Article Articles Score: 2
Article Accessibility Score: 3
SUBMIT PAPER ASK QUESTION
International Category Code (ICC):
ICC-1802
Publisher: Lifescience Global Inc.
International Journal Address (IAA):
IAA.ZONE/2369108173355
eISSN
:
2369 - 3355
VALID
ISSN Validator
Abstract
In this study, the use of sol-gel/epoxy adhesive based on the combination of organic and inorganic components within the adhesive matrix have been studied. The combination of different amounts of γ-Al2O3 nano-particles to the adhesive matrix was evaluated. Mild steel specimens were prepared for lap joints, which were cured in an oven at 200°C for 16 hours. The bond strength of the sol-gel/epoxy matrix was investigated using a universal tensile test machine. The presence of Al-OH and/or Si-OH bonds increases causing an increase in the strength of the bulk material. This process is seen through the appearance of an absorption peak shoulder which appears in the range of ~ 1088 to1100 cm-1 which corresponds to Al-O-Si or Si-O-Si. The maximum adhesive strength of composite sol-gel/epoxy adhesive recorded was 23±0.4 MPa. This was obtained when small amounts of γ-Al2O3 nano-particles (4.0 wt%), were incorporated within the matrix. However, a...
