×
Suggest this Article to:
TOP INDEXERS
Public Paper
-
Development of Application Software for Stock Material Selection for Manufacturing of Shafts
ISSN: en
Publisher: author
Development of Application Software for Stock Material Selection for Manufacturing of Shafts
View Paper PDF
Abstract
Proper production planning ensures judicious utilization of manufacturing resources. It is understandable that the administrative rigor of planning appreciates intervention of programmable software to ease the stress and improve efficiency. The present study developed application software to predict and select stock material of minimum dimension ahead of turning of shafts of a specified finished dimension. Microsoft’s Visual Studio Integrated Development Environment (IDE) was utilized to develop the multi-module software application. Finished dimension data supplied (diameter and Length) are the operands utilized at arriving at required raw dimension data. The keyed in data (diameter and length) are the program variables used by the application at run time. Decision constructs based on standard material sizes (constants) was keyed into the application for raw dimension diameter data, ranging from 0 – 300 and the Standard sizes are...
SUBMIT CONCEPT ASK QUESTION
International Category Code (ICC):
ICC-0202
Oduola. M. O.
International Article Address (IAA):
IAA.ZONE/en8407en
Paper Profile:
Private
Visitors: 0
Paper Evaluation: Pending
ASI-Factor: 0
Paper Improving: Pending
Paper Flaws: 0
References
No citation was entered yet.
